​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​​Technical Bulletins

​EIFS

• ​Acceptable Sealants to use with Senergy Wall Systems​​
• Application of Channeled Adhesive CI Design in Elevated Temperatures
• Code Compliance of Senerflex Classic PB, Secondary Weather Barrier and Senturion EIFS
• Guidelines for Inspecting EIFS Clad Homes​​
• ​Senturion Systems Methods of Attachment​
  
• The Importance of Properly Backwrapping Drainage EIFS​
  
• ​​The Importance of Using the Proper Notched Trowel with EIFS
  
• Platinum CI Neopor GPS Plus Supplementary Fasteners
• Neopor GPS Plus Rigid Insulation Boardand for use with Platinum CI EIFS
  
• Senerflex Classic PB over Corrugated Metal Panels​
  

Air/Water-Resistive Barriers

• ​Air / Water-Resistive / Vapor Barrier Application Guidelines​
• Case Study: Senershield-R at Fort Bliss​
  
• Spray Application of Senershield-R/-RS/​-VB
• Acceptable Sealants for use with Senershield-R/-RS/​-VB​​
• Fastener Self-Sealing for Senershield Air/Water-Resistive Barriers​
  

Masonry Veneer Systems

• Masonry Veneer Systems Mortar - Types, Definitions and Uses Technical Bulletin​
  
• Masonry Veneer Systems Efflorescence​​
  
• Channeled Adhesive CI Design with MaxGrip Veneer Mortar System Testing​​
  
• Resurfacing EIFS with Adhered Masonry Veneer​​
  
• Insulated Masonry Veneer System Test Study on Seismic and Racking Performance​
  
• Insulated Masonry Veneer System Test Study on Short-Term Deflection Performance​​
  

​​​​Stucco

• Accepted Stucco Wall Systems Lath and Trim Accessories​
• Master Builders Solutions and SPEC MIX Stucco System Program Support Bulletin​
• Cement-Board Stucco 500 & 1000 Trim Accessories
• Senergy Stucco Wall System with PermaLath Reinforcement Trim Accessories
• ​Water-Resistive Barrier Requirements for Cement Plaster Stucco
• PermaLath 1000 Test Results​​

​Platinum CI Stucco

• Guidelines for Attaching to Wood or Steel Framed Assemblies
  
• ​Platinum CI Stucco Non-Combustible Construction​
• Platinum CI Stucco Systems Key Detail Considerations​​​

​​​​EIFS Resurfacing

• Procedure for Cleaning EIFS​
  
• Procedure for Removing Efflorescence
• Procedure for Recoating EIFS​​​
  
• Procedure for Reapplying Textured Finish
• Procedure for Repairing Cracks in EIFS​​
• Procedure for Repairing Cracks at Aesthetic Joints in EIFS​
• ​Procedure for Repairing Puncture Damage in EIFS
  
• Procedure for Reattachment of EIFS
  
• Procedure for Replacement of Sealant Joints in EIFS
• Procedure for Installation of an Overlay Sealant Joint in EIFS
• Procedure for Resurfacing EIFS
  
• Procedure for Recladding Existing Structures
• SMaRT EIFS Procedures​
  

​​Stucco Resurfacing

• Procedure for Cleaning Stucco
• Procedure for Removing Efflorescense on Stucco
• Procedure for Recoating Stucco
• Procedure for Reapplying Textured Finish
• Procedure for Repairing Blistered Acrylic Stucco Finish
• Procedure for Patching Cracked Stucco
• Procedure for Repairing Stucco Cracks
• Procedure for Resurfacing Stucco
  

​​Restoration & Reclad

• Basics of Conducting Adhesion Testing
  
• Technical Solutions for the Renovation of Brick and Masonry​​​​
  

​Best Practices

• Application of Textured Acrylic Finishes in Indoor Pool and Spa Areas
• Cool Weather Application of EIFS, Stucco, and Acrylic Surfacing Systems
• Critical Light and Tips to Minimize Aesthetic Irregularities
  
• Coatings Spray Equipment Recommendations​
  
• Tenting and Inclement Weather Application​
• Simple Method for Testing Bond over Painted Surfaces
• Tips for Optimizing Performance Sealant Joints within Master Builders Solution Wall Systems
• ​Maintenance, Cleaning and Repair Guidelines for Senergy Wall Systems and Finish
• Prevention and Treatment of Efflorescence
  

Special Interest

• Application of Finishes over Acceptable Substrates
• Application of Metallic Surfacing Systems' Guidelines
  
• Guideline Procedures for Coatings Mock-Ups​
  
• Warranty Issuance Instructions
• ​Wash Off of Uncured Coatings and Finishes
• Sealants and Wall Systems Warranty​